Automate Fill/Kill for PO Lines

 4 Replies
 0 Subscribed to this topic
 1 Subscribed to this forum
Sort:
Author
Messages
brupp
Veteran Member Send Private Message
Posts: 165
Veteran Member

Hello - We are going LUM/JIT with a vendor soon.  As PO's are issued, is there a way to automate the cancellation of a PO line when the vendor cannot fill it 100%?  Thanks.

Kat V
Veteran Member Send Private Message
Posts: 1020
Veteran Member
We've been JIT since 1998 but have always left Cancel Remaining up to the Buyer working their open orders. But you could build an IPA:
When PO Line Received Qty > 0 and < PO Line Quantity, then Change Cancel Qty to PO Line Quantity - PO Line Received Qty and CHANGE.
Run that nightly?

Jay S
Basic Member Send Private Message
Posts: 6
Basic Member

We currently use the YNQ segment on the 856 to Cancel BOs for specific LUM/JIT accounts.  This required coordination with the vendor (Medline) to send only on the accounts we requested (not our Bulk Accounts)

See Infor KB 1471128EDI Using YNQ Segment to set Cancel Backorder in MA531CSV   

The benefit of this method as compared to using the PO10.1 or PO10.2 Cancel Back Order is that the YNQ is line specific.

UTMCK
New Member Send Private Message
Posts: 2
New Member

Kat V, Why have you always left Cancel Remaining up to the buyer? What are the drawbacks of automating?

Kat V
Veteran Member Send Private Message
Posts: 1020
Veteran Member
We're a JIT organization and the departments will be given the choice to wait for the product or cancel and look for a sub. I don't think we've really looked at it since go live in 1998. I'm going to ask our new Admin Director if it's something to look at. We only accept the 856 from Cardinal, so I'm not sure if it's going to make that big an impact on our PO223.