Prev
Next
Forums Integration / Customization S3 Customization/Development

EMSS upgrade with customization

 3 Replies
 0 Subscribed to this topic
 17 Subscribed to this forum
Sort:
Author
Messages
L G
Advanced Member Send Private Message
Posts: 38
Advanced Member
6/1/2011 1:39 PM
Hi I would like to know what steps we need to take during an EMSS and CBL upgrade? We have a few customizations that we need to preserve. Does Lawson take a backup of EMSS modified files when we do an upgrade as it does during a CTP installation. Or do we have to manually take a backup of customizations? What steps do you all follow before doing an upgrade of EMSS?
mark.cook
Veteran Member Send Private Message
Posts: 444
Veteran Member
6/1/2011 1:47 PM
We documented / copied any customizations that we could, then installed the new version of EMSS and applied the changes.
JudeBac
Veteran Member Send Private Message
Posts: 129
Veteran Member
6/1/2011 1:55 PM
Hi Lalit, Lawson will not consider your customization. It will be overwritten. You will need to backup your old EMSS files which includes your customized files. Unfortunately, you cannot just restore the old version into the new upgraded version. You will need to write the custom codes again into the new EMSS files, yes manually. Depends on the upgrade, it may or may not be that complicated. I remember the upgrade from 8 to 9, some files with custom codes no longer exists and was consolidated into another file. From 9015 to 9017, some functions and variables changed too. Good luck, Jude
L G
Advanced Member Send Private Message
Posts: 38
Advanced Member
6/1/2011 2:54 PM
Thanks we are moving from 9.0.1.3 to 9.0.1.5 I guess I have to do the following steps 1) List out all the customizations in xhrnet and xbnnet folders 2) Then take back up of xbnnet and xhrnet folders 3) Retrofit the customizations in the affected files