Prev
Next
Forums Infor / Lawson Platforms S3 Systems Administration

Jobdump/Jobload

 4 Replies
 1 Subscribed to this topic
 27 Subscribed to this forum
Sort:
Author
Messages
Greg Moeller
Veteran Member Send Private Message
Posts: 1498
Veteran Member
6/28/2022 4:23 PM

I'm trying to transfer jobs between users on the same environment.  There's way too many steps and intracate details to manually set them up...  so...

jobdump -d -o Job -v UserName GHSNT\JoSchmo -v JobName AM220MTHLY| tee d:\tmp\jobdump.AM220MTHLY.dmp

jobload -m UserName GHSNT\JoSchmo GHSNT\JoeCool d:\tmp\jobdump.AM220MTHLY.dmp Should return: Validation mode. Job UserName=GHSNT\JoeCool JobName=AM220MTHLY

Then after that, I need to add a -c to the command to actually write to the database

jobload -c -m UserName GHSNT\JoSchmo GHSNT\JoeCool d:\tmp\jobdump.AM220MTHLY.dmp Updated Job UserName=GHSNT\JoeCool JobName=AM220MTHLY

But now user JoeCool cannot run the job... I can see it listed just fine in InforOS in the JobList but it has disappeard

from JoeCool's list to execute.  Is there something that I'm missing?

John Henley
Send Private Message
Posts: 3351
6/29/2022 5:16 PM
Hi Greg, your steps look correct. Only thing might be an IOS cache refresh? Did you try pulling up the job under his username in jobdef in LID ?
Thanks for using the LawsonGuru.com forums!
John
Greg Moeller
Veteran Member Send Private Message
Posts: 1498
Veteran Member
6/29/2022 5:57 PM

You may but LID is actually my preferred job configuration utility. I've tried looking them up in LID - successfully. Even in InforOS - success.  Perhaps I just need to log on and see what he's seeing?

Attachments
Greg Moeller
Veteran Member Send Private Message
Posts: 1498
Veteran Member
7/6/2022 4:59 PM
OK, I've logged on and seen what the user can see... He cannot see the jobs that were set up for him under his profile. Question: Is there a different table to which the Multi-Step jobs belong to? He can only see (so far) the single step jobs that he's defined for himself.
Greg Moeller
Veteran Member Send Private Message
Posts: 1498
Veteran Member
7/25/2022 9:57 PM
In case anyone else can benefit from this solution: Turns out if you create a multi-step job and don't give security access to 1 step, it removes the entire job from your list of jobs. Granting security to all steps fixed the ability to see by the user.