Prev
Next
Forums Infor / Lawson Platforms S3 Systems Administration

Windows 2008 AD LDS Setup for Lawson

 7 Replies
 0 Subscribed to this topic
 27 Subscribed to this forum
Sort:
Author
Messages
JohnO
Basic Member
Posts: 15
Basic Member
5/10/2010 8:49 PM
    I am trying to install a new environment for Lawson 9.0.1 and have run into an issue where the LDAP user validation test fails during the install. I setup an AD LDS partition for Lawason and created a used in the LDAP partition and put the user in the administration group in the partition created for Lawson. I believe I must be missing some security on the schema that is causing this error. Has anyone setup a new environment on 2008 using AD LDS? If so what steps did you go through to get the security correctly setup for Lawson? Any help would be greatly appreciated.
    Jimmy Chiu
    Veteran Member
    Posts: 641
    Veteran Member
    5/11/2010 2:42 PM
      1) use ADSI edit to connect to your Schema
      2) open up properties of CN=Organization
      3) in Attribute Editor, highlight "possSuperiors" and click edit
      4) type in "container" in "value to add" box and click add, click ok, click apply then ok in attribute editor
      5) reboot and you should be set on the ldap part.
      JohnO
      Basic Member
      Posts: 15
      Basic Member
      5/11/2010 6:40 PM
        Thanks that solved my issue.
        Mariale
        Posts: 3
        12/1/2010 1:47 PM
          I am installing the new environment for Lawson 9.0.1 (W2008)
          and I have problems When I try to change my Schema

          I did all theses steps :
          1) use ADSI edit to connect to your Schema
          2) open up properties of CN=Organization
          3) in Attribute Editor, highlight "possSuperiors" and click edit
          4) type in "container" in "value to add" box and click add, click ok, click apply then ok in attribute editor

          Where I clic APPLY I get this error " Insufficient access rights to perform the operation"

          And I don't know what can I do...



          Jimmy Chiu
          Veteran Member
          Posts: 641
          Veteran Member
          12/2/2010 6:41 PM
            the account you are using to change schema does not have administrative right. Log in with account iwth the right to change schema.
            Mariale
            Posts: 3
            12/2/2010 7:54 PM
              Hi Jimmy thanks for response.

              I am using the local administrator account to change the schema. :-(
              Jimmy Chiu
              Veteran Member
              Posts: 641
              Veteran Member
              12/6/2010 6:20 PM
                Your local admin account might not have the admin right to ADLDS instance. check this:


                Mariale
                Posts: 3
                12/8/2010 2:45 PM
                  Jimmy, thanks for your help. The issue was resolved