Prev
Next
Forums Supply Chain Management Lawson S3 Supply Chain

IC11 change UOM: Error - "Cannot change UOM info; PO interface records exist"

 3 Replies
 0 Subscribed to this topic
 38 Subscribed to this forum
Sort:
Author
Messages
Johnmac
Advanced Member
Posts: 35
Advanced Member
10/9/2015 12:04 PM

    I am trying to add EA as the lowest UOM in IC11.

    I’ve followed these steps:

    1.    IC11 UOM tab – add EA UOM with all priorities to 2 and click change

    2.    PO115 – change UOM for CA to EA – run in update mode

    3.    IC11 main tab – change stock UOM from CA to EA and click change

    4.    IC11 UOM tab – change conversion factor and click change: error: "Cannot change UOM info; PO interface records exist".

    Any help is greatly appreciated.

    JonA
    Veteran Member
    Posts: 1163
    Veteran Member
    10/9/2015 12:16 PM
      The item exists in PO23. I would not recommend making any changes to your uom structure when open orders exist.
      Jon Athey - Sr. Supply Chain Analyst - Materials Management - MyMichigan Health
      Johnmac
      Advanced Member
      Posts: 35
      Advanced Member
      10/9/2015 12:25 PM
        This UOM change is very important because units are asking for EA and we are unable to issue by EA.
        This item is an inventory item.
        I checked PO23 - item was not found so I checked IC66, found the item and deleted the replenishment request.
        I tried to change the conversion but received the same error message: "Cannot change UOM info; PO interface records exist".

        JonA
        Veteran Member
        Posts: 1163
        Veteran Member
        10/9/2015 12:47 PM
          Can you query the POINTERFAC table and see if it exists there?
          Jon Athey - Sr. Supply Chain Analyst - Materials Management - MyMichigan Health